Cutting Height Adjustments
• Rotate height adjust crank handles (item #8
and #5 in fig. 4) in a clockwise direction to
raise the mower and in a counter-clockwise
direction to lower.
• Make sure that height adjustment is the same
on both sides of the mower, as indicated by
the graduated scales on the height
adjustment tubes.
• NOTE: Graduated scales are for reference
only.
Front to Back Adjustment
To obtain the best cutting results, the mower
housing
should be adjusted so that the front is approximately
¼” to ¾” lower that the rear. To check for front to
back adjustment, measure from the bottom edge of
the deck to the ground at both the front and rear of
the deck.
Tow Hitch Offset Assembly
This Trailmower has been designed to run offset from
the center of the tow vehicle to provide additional
cutting width. (Refer to fig. 2 for assembly
information)
• The adjustable tow hitch of this mower can
be assembled in several positions from
straight to 58” offset to either side.
•
We recommend when towing with a tow
vehicle equipped with a mid mount mower to
offset the Trailmower to overlap the cut of
the mid mount mower by 6”. This will need to
be adjusted depending on the type of terrain,
obstacles, and the tow vehicle being used.
•
If your tow vehicle is not equipped with a mid
mount mower the hitch can be adjusted to a
straight position, but we recommend using
the offset position to eliminate grass being
crushed by the tow vehicle.
Tow Hitch Offset Assembly
• Please refer to figure 2 for the assembly of
the hitch bar.
Before Starting Engine
•
Fill engine with oil. (See engine manual for
proper procedure and requirements.)
• Add gasoline. Fill tank using fresh clean
unleaded gasoline.
To Start Engine
•
Make sure spark plug wire is properly
connected.
•
Place throttle control in “Choke” position if the
engine is cold. A warm engine may not
require choking to start.
•
Turn key to start position. Release key
immediately when engine starts.
• When engine starts, move throttle control to
the “Run” position. (Full throttle)
• Allow engine to warm up for a few minutes
before engaging blades.
NOTE: If at high altitude (above 3000 ft) or in cold
temperatures (below 32° F), the carburetor fuel
mixture may need to be adjusted for best
performance. (See service and adjustments
section of engine manual.)
Shut off mower and remove
spark plug wire before making
any adjustments to the mower.
Shut off mower and remove
spark plug wire before making
any adjustments to the mower.
Fill to bottom of fuel tank filler
neck. Do not overfill; wipe off
spilled oil or fuel. Do not store,
spill or use gasoline near open
flame
Keep the blade clutch lever in
“Disengaged” position when
starting engine
8
(9 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals